Jato Roller came in planning on putting a remote start on it

[Gee]

Here's just a couple of shots of the Jato with the remote start wiring cleaned up. I was able to get the duratrax esc to arm with my Tx. It was smaller then the xl-5 I was using. I also swapped out the sr3100 receiver I was using for the sr3500 (I think that the model #) it's the small version. Got it all to fit into the receivers compartment and center compartment. Looks a lot better with the wires all tucked away. I left the connetion between the ez-start board and the onboard ez-start wire harness. That way I could use a ez-start wand if anything goes haywire with the remote start setup.

Before I cleaned up the wiring.


After the wiring and components were all tucked away.




Thanks for your guys help and support during this project