Mod1 spur to New Emaxx trans

[junkman]

I don't really remember what the spur on the older e-maxxes look like, but on everything I have that has the revo spec slipper like the 3905 e-maxx I run monster gt spurs. You just have to enlarge the center hole a bit for the bearing, and enlarge 3 of the slipper peg holes for the slipper back plate to slip through. About 2 minutes worth of modding and it drops right on, you can get them on 46-52 tooth for 4/5 bucks each.

[lincpimp]

A junkman said... I swap the 5x11 slipper bearing to a 5x10 bearing, that way you only have to open up the center hold of the mgt spur slightly, much less chance of getting it out of round that way.