drivecups - RC-Monster Forums

		RC-Monster Forums > Support Forums > Revo
drivecups

Reply

Rate Thread

	(#1)
magman RC-Monster Dual Brushless Offline Posts: 4,236 Join Date: Dec 2007 Location: Cape Cod, Mass.	04.03.2009, 09:14 PM So the 8mm UE cups will fit on the v3 output shafts? 1. MBX-6 T8 1900KV, RX8 ON 4S 2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S

Old

(#2)

George16

Supermaxx

Offline

Posts: 2,031

Join Date: Oct 2007

Location: Earth

04.03.2009, 09:17 PM

Quote:

Originally Posted by magman

View Post

So the 8mm UE cups will fit on the v3 output shafts?

No. The V3 uses a pinion which has a 5mm end(mugen, I believe). The V1 and V2 uses the Hot Bodies diff which have a 8mm pinion shaft. Sorry for the confusion.

Castle Neu 1520 on 6S LiPo Powered Gmaxx (Nitro Killer)
Predator with OS .21TM
Supermaxx with Mach .26
Revo with OS .18TZ
Kyosho ST-RR Conversion
Ofna CR with Tekin ESC/Motor (2)

Reply With Quote

Reply

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Forum Rules

Forum Jump

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com