2nd Version "MaxxEXT 2.0"

after a lot sun, water and kite-surfing i'm back into rc

i make the chassis last 2007 and a last version 2008
also i required was a 168mm long center driveshaft in the rear
and i make a new e-maxx input shaft to handle the revo slipperunit


and here we go 10cm/ 3.93700787 inch longer as the stock 3906Maxx






my "MaxxEXT 2.0"

switched to Bk 9920/ 20XL-12
with Schulze LipoDimatic-14
6s2p kokam
revo slipper 40spur
40/16 testing in 2nd gear








Chassis mounted low (not lowest)





Chassis mounted high (not highest/ but high enough)

Topview




Bottomview




left hand side




right hand side




backview




transmission/ esc/ motor





and we are back in 2009

ya "What's_nitro?"

as i sold it i clean it up and i found bees and grass in therein

but the pletti i gone to brutal

thx

wheelbase is axle to axle 425mm/ 16.7322835 inch

and wide Maxx xcr suspension