**My FLM CCNeu Maxx Nearly Completed**

[squeeforever]

Umm...I wouldn't do that. Just use some o-rings in the drive cup...

[Sylvester]

Originally Posted by squeeforever

Umm...I wouldn't do that. Just use some o-rings in the drive cup...

+1
those screws might cause a ton of friction which will heat up your drivetrain some, o-rings would be the best solution.

[ANGRY-ALIEN]

Originally Posted by Sylvester

+1
those screws might cause a ton of friction which will heat up your drivetrain some, o-rings would be the best solution.

I was thinking about the excess vibration it may cause too... would simple rubber/foam inserts work by having them push out on to the shaft?

Alien

[Sylvester]

Originally Posted by ANGRY-ALIEN

I was thinking about the excess vibration it may cause too... would simple rubber/foam inserts work by having them push out on to the shaft?

Alien

Rubber and or foam would work, i personally used gas tubing in between the output shaft and driveshaft and never had a problem.