I beseech thee, oh Brushless Gods....

oh yeah...I'm sure it'll be pretty good.

Well, at least I really hope it does. I'll try to get some clips for you.

[zeropointbug]

My Villain is actually the EVX, not the EVX-2... which I hear is of lesser quality, robustness? IIRC?

I have the watercooling kit for it which keeps the Titans cool when skippin over the water at 25mph (estimated), it's pretty darn quick. At full throttle for the entire run, the runtime is around 8 mins. I hooked the Eagletree up to it, and it draws around 350 - 400 watts, and thats continuous. The 5s1p pack can get up to around 150F when I take it out on a hot day. Motors are 125F.

I would like to be up at just over 30mph and run nice and cool with some brushless motors, longer runtime too I guess.

[steveo]

i had a old villian that had lying around the shed at least 12 years old, when i was getting into FE boats found this article and did the same thing only i used a single spec 700 motor 12 cells about 30mph, use good hardware makes for a fun project not much room for most hardware make sure you measure

look for p-offshore,http://www.lousfastrc.com/