Need info for 80mph brushless truggy...

[Over_revO]

Originally Posted by jzemaxx

Been their done that.....

1521 1.5Don 12S on a XTM MMT. Bigger, heavier then a LST and the biggest MT you can buy that is 1/8th scale. That motor NEVER got hot and the ESC never got hot doing speed runs. The fastest pass on camera was a 80.4mph.

http://www.youtube.com/watch?v=ERY9_...e=channel_page

I remember seeing your vids Jzemaxx, good job!, im also registered on the fast-rc forum, dunno if you remember me.... i dont visit the forum a lot. hehe

What ESC you were running on 12S ?
I want to use teh setup on a truggy, like a CRT or Mutilator from Ofna.


Any info will be greatly appreciated.

Mike :)

[DwightSchrute]

Originally Posted by Over_revO

I remember seeing your vids Jzemaxx, good job!, im also registered on the fast-rc forum, dunno if you remember me.... i dont visit the forum a lot. hehe

What ESC you were running on 12S ?
I want to use teh setup on a truggy, like a CRT or Mutilator from Ofna.


Any info will be greatly appreciated.

Mike :)

If i'm remembering jzemaxx's thread right he was using an HV-110 or a Turnigy unit i think.

As for finding the pistix, they are for sale again.
here's a link:

http://www.mikessubworks.com/page1.html

just look to the left under electronics and select speed controls and there it is.


my biggest concern for the 80mph speeds would be tires at that point. i always thought phaltliners were good for about 75mph but i blew one of those to pieces just the other day. i've got some foams on order, but they're not here yet.



i didn't have the gps on it but i'm guessing i was well over 70 geared 36/25 on 6S. i replaced that one and proceeded to blow another 3 so i'm done with the phaltliners i think.

here's the foams i'm gonna try:

http://www.imexrc.com/servlet/the-25...M-GREEN/Detail