HB GT10 / LS10 Mods Upgrades Alternate Parts

[Gee]

Thanks. It is nice to open the hood and see just the engine with a good view of every wire and hose. My little winter wagon is a 84 Camery. Old car but still packed with wires hoses and sensors. I don't know what to look at when I open it's hood. Went to go start it up for a bi-weekly warmup. It starts, runs 15-20 sec and dies. Opened the hood to look for airflow sensor I read might be the problem. I'm still looking.,,,


I've got around the same # of rcs. Always something to fix and it's hard to share the hop-ups between them all. For that matter hard to buy all parts so they are all in running order at the same time. It does give a person more option of which Paul to steal from to pay Peter though.

You did a good job selling off your nitro gear. Paid for most of the brushless setup. I grabbed a Turnigy last time I orded a lipo from HC but haven't put it in anyting yet. I think it was a 3300kv motor. Maybe I got the 2700 cuz I have a 3300kv motor. I will have to look and see how it does. Sound like your is working well. Does the shaft seem short on yours?

[Bondonutz]

Yeah it's a tick on the short side. The shaft is a little more than 3/4 of the way through the pinion, Plenty for this application. If it was a 1/8 scale running 5s and big jumps I'd be a little more concerned.
BTW, My BAD- I have the 2300kv Turnigy BL motor,NOT 2700.