sick of paying $3 for deans plugs

[Marvin]

Originally Posted by lincpimp

I would like a polarized bullet connector housing that could handle something like 5mm bullets. I like the idea of the ec5 connector, but I think it could be a bit bigger for our high current uses.

I use EC5's and am pretty sure they are 5mm bullets in there. They never get warm, even when racing. I've got an unmade pair here, alongside a 4mm connector, and the EC5 bullet is definately a lot bigger. It dwarfs the 4mm completely.

The diameter is definately 5mm too, I just measured it. This isn't the bent loop bit either, but the tip widest part of the tip.

[lincpimp]

Originally Posted by Marvin

I use EC5's and am pretty sure they are 5mm bullets in there. They never get warm, even when racing. I've got an unmade pair here, alongside a 4mm connector, and the EC5 bullet is definately a lot bigger. It dwarfs the 4mm completely.

The diameter is definately 5mm too, I just measured it. This isn't the bent loop bit either, but the tip widest part of the tip.

Hmm, I may have to pick some up and look at them. The HC ec5 knock offs say 4mm in the description though. I will have to buy both and see if there is any difference.