MMM in Slash - Question

[fastbaja5b]

Well after toasting the stock XL5 speedy I needed something to throw in the Slash.



I am only running stock corr so 2s Lipo and the Titan 550 is a must, my question is there is talk of running in the wet and I am curious how the MMM will fare. Is there anything I can do to protect it? Ie RTV gasket (silicone) around the bullet connectors on the board and try and seal it the best I can? How do these go with "splash damage" with muddy water, obviously I won't be playing submarines or anything.

PS, the Titan 550 hammers on 3s with the MMM, do you think the speedy would have any issues running say an E-Maxx Titan on 3/4s? At least until I get my VXL motor fixed (end cap and bearings)

[rootar]

the MMM will run the pair stock titans 4s easily, you could also sneak 5s on there and watch it rip, but dont expect the motors to last very long....

[fastbaja5b]

You reckon the stock E-Maxx titans on 4s would be an improvement on the Titan 12t on 2s?