My e-revo brushless edition build

[shaunjohnson]

Originally Posted by mistercrash

I have seen aluminum chassis' that were bent upwards and those bulkheads ruined because the M4 screws were pulled out of them when the chassis bent.

been there done that, did your threaded insert mod and i'll never go back
one of the best mods for revo ever those threaded inserts!!

[jpoprock]

Originally Posted by shaunjohnson

been there done that, did your threaded insert mod and i'll never go back
one of the best mods for revo ever those threaded inserts!!

Hey Shaun/MistaCrash...

I've looked thru this thread (which is a LOT of lookin!), and I can't seem to find this mod that you're talking about. I was hoping you could direct me to the post that talks about it?

I like some of the ideas shown on how to strengthen up the rear wing area. I like the one where the shafts mount to the back of the truck, then up to the wing itself. I'm going to get a hold of some P2 rods with hopes to brace my wing up.

Question though.. will I have to fab up a mount for it on the shock mount? My Tekin stabilizer kit has a small screw in the center, but I'm not sure it's adequate to hold. I have some CF that I can cut up and make a mount. I just don't remember if I have a countersink bit. I think I do.

Also, has it been decided as to which "dirt flap" is the best design? Is it the one where you used Gorilla tape, or is it the one where you cut a single piece of rubber? I'm sure both are great!

So, do I still sound mad? LOL! I hope not. I never intend to come off that way ever! And if I do choose to be mad, you'll know it.

[mistercrash]

Originally Posted by jpoprock

Hey Shaun/MistaCrash...

I've looked thru this thread (which is a LOT of lookin!), and I can't seem to find this mod that you're talking about. I was hoping you could direct me to the post that talks about it?

I like some of the ideas shown on how to strengthen up the rear wing area. I like the one where the shafts mount to the back of the truck, then up to the wing itself. I'm going to get a hold of some P2 rods with hopes to brace my wing up.

Question though.. will I have to fab up a mount for it on the shock mount? My Tekin stabilizer kit has a small screw in the center, but I'm not sure it's adequate to hold. I have some CF that I can cut up and make a mount. I just don't remember if I have a countersink bit. I think I do.



Also, has it been decided as to which "dirt flap" is the best design? Is it the one where you used Gorilla tape, or is it the one where you cut a single piece of rubber? I'm sure both are great!

So, do I still sound mad? LOL! I hope not. I never intend to come off that way ever! And if I do choose to be mad, you'll know it.

If you're asking about the no slop Ofna hexes it starts at post #7. For the rear wing I would say yes you would have to make a mount to go on the rear shock tower. The Gorilla tape dirt flaps work good but they are a little soft, the stiff rubber ones were better. No you don't sound mad at all.