EZ Run 80 Meltdown

[BrianG]

Well, the MM has about the same rating as the HobbyWing 80 as far as the FETs go, so I would just be careful about mesh tightness. Also might help to dial in some punch control (to help reduce the huge instantaneous currents on takeoff) and add a couple extra low-ESR caps to the power leads.

And since the MM has a linear BEC, you will want to disable it (remove the red wire from the throttle cable) and use an external switching BEC.

[vtxnitro]

OOPs I mistyped I ordered a mamba monster not a mamba max

[pinolelst]

15 degrees timing sounds high for a 2 pole motor...

Steve

[vtxnitro]

Might be I just left it where it was from the factory, figured that would be safe. Guess I was wrong

[emaxxnitro]

Originally Posted by vtxnitro

OOPs I mistyped I ordered a mamba monster not a mamba max

oh then dont worry about it if your mesh is off it will kill the motor or melt the gear and the mamba monster will laugh at it! the mmm is better or = to the hw150