Ghetto solder tab covers

[BrianG]

I don't think anything could go wrong unless someting conductive happens to short across those connections. But, I just don't like esposed wires; seems unfinished.

The pen caps are just to see how well it works. Easy to make; a little dremel work and they just snap on and off. I don't pics of this exact setup, but aside from the motor, it's the same as the old pics of my XT8 (in my conversions page in sig) just a different motor.

Actually, the original rotor is still in the motor. I figured I would see if it holds up before I swapped it for the newer one that was included in the box. So far so good.