Finally got me an Eagletree Data Logger!

[sikeston34m]

The setup got changed around again.

This time, with the goal of getting amp draw down to a decent level while maintaining a good level of performance.

The setup is:

E Revo
MM Pro (lowest timing, 100% punch control)
5S 20C 5000mah Turnigy
Medusa 36-70-2000 geared 14/52 (around 35mph)

This setup performs well. Top Speed sees the motor spinning around 38000rpm.

I tried this setup on 4S (Top Speed 28mph), and the graph from it is almost identical to the 5S Graph. Hmmmmm.......... I wonder what it would do on 6S? Don't have the 6S setup at the moment, but it does have me curious.

Most of the spikes are right around 65-70 amps. This should be accurate for the logger since it isn't exceeding 100 amps.

[sikeston34m]

I just acquired some Apogee 3S 3800mah packs. So far, they've been pretty impressive.

The Limn chemistry doesn't hold the voltage under a load that the Turnigy's do, but they come out of the run pretty cool.

This 6S setup is making over 2100 watts!

E Revo
MMM ESC
Medusa 36-70-2000kv gearing 14/52
Apogee 6S 3800mah

They came out of this 20 minute run just barely warm and resting at 3.7 volts per cell.