Its finally here!!!!!

[Arct1k]

I run it on my G3R - It requires from fine placement but a 44T spur is easy, a 46T is tight and 48T required a tickle to the braces...

[JERRY2KONE]

Originally Posted by Arct1k

I run it on my G3R - It requires from fine placement but a 44T spur is easy, a 46T is tight and 48T required a tickle to the braces...

SO do you already this design setup in your trucks? So it is the answer to the original center diff mount that he made two years ago????

[George16]

Originally Posted by Arct1k

I run it on my G3R - It requires from fine placement but a 44T spur is easy, a 46T is tight and 48T required a tickle to the braces...

Pics?????????????????????????

[_paralyzed_]

nothing. luckily Linc quoted me, so my shame shall be immortalized

[lincpimp]

Originally Posted by JERRY2KONE

Just wheel yourself over to James's house and chase him around with your chair while you hang on to a big 12 gage shotgun. That will relieve some stress for ya. As usual this is his fault anyway.

Man, you old guys sure do get horny over nothing huh?

Originally Posted by Arct1k

I run it on my G3R - It requires from fine placement but a 44T spur is easy, a 46T is tight and 48T required a tickle to the braces...

Pics please Chris!

Originally Posted by George16

Pics?????????????????????????

+1

Originally Posted by _paralyzed_

I'm so pissed off over this outcome. Nothing I do with r/c seems to go in my favor. There is a 13 page thread with pictures showing specifically what customers wanted. I've been holding on to $$300 in my pay-pal account because I didn't know what 2 of these would cost. I feel like blowing the money on weed and relapsing, then throwing my stupid trucks through the wall. I'm literally hot over this, I feel like my blood is boiling. It doen't matter if anybody reponds to this post, I'm signing off for the night

Don't get those fat girl panties in a twist dude. I am sure that we can figure something out for you. Hissy fits will not get you anywhere...

[_paralyzed_]

thanks for quoting me Linc. Sorry for the threadjack Jerry. I went to my room and pouted, I feel much better now.

[_paralyzed_]

Pic of Arctik's G3R people are crying for

[JThiessen]

Originally Posted by _paralyzed_

Pic of Arctik's G3R people are crying for

Ok - quoting you again!!!!! Does that mount look bent to anyone else? I know optical illusions can happend with digital photos, but something is out of alignment there.....

Second, in the pic in the RCM store, the small mount doesn't have holes in the bottom - are we going to have to drill and tap that to suit? Not a problem for me, but just wanted clarification.

[JERRY2KONE]

Originally Posted by _paralyzed_

thanks for quoting me Linc. Sorry for the threadjack Jerry. I went to my room and pouted, I feel much better now.

That is OK Harold. I was feeling almost as disappointed as you when I saw that it was not the same thing. Of course you are feeling bad because you sold your only original unit. Mike assures me that it will work just fine with a few little tweeks, so we shall see how it goes. I have two comming my way. We all needed to take a step back and relaxe just a bit. If it works out, then it works out. If not then we will rant and rave about the short commings of the newly designed unit at that time and let Mike deal with it. Life is good Harold.