Instead of a Pinion, Use a clutch bell? and double check my gearing please.

[Finnster]

I don't know if you can use a CB with Mikes CD mount. The adapter plus CB will extend the gear face out quite a bit. You maybe able to reverse the CD so that the spur is opposite of the motor, but IDK.

Tekno always used set back motor mount to acct for the length

[_paralyzed_]

Originally Posted by Finnster

Tekno always used set back motor mount to acct for the length

Harold always used rubber donut sex spacers to acct for the length

I fixed that for ya, Finn.

[Finnster]

Originally Posted by _paralyzed_

Harold always used rubber donut sex spacers to acct for the length

I fixed that for ya, Finn.

Well you've gotten modest. Linc said you always liked the full length colonoscopy

[nuz69]

Hello,
Just to say that clutch bell setup will increase the distance between front bearing and mesh contact, resulting in a lot of stress on the front bearing !!! And that is BAD for efficiency and bearing ;) Forget it... Contact some pinions suppliers and buy them by quantity of 20