New Mamba software (beta) posted today

[ANGRY-ALIEN]

Originally Posted by brushlessboy16

Yay! I had put the old-new sofware on my truck yesterday and went to run it today and it was dead as a doorknob. Got home and saw this thread and intalled the new-new software and it runs, no more paperweights :) thanks for the speedy fix castle creations.

Hmmmm... good to know you got the fix working.

Originally Posted by bryan

Angry alien??????????

No go for me man... I downloaded the new firmware (CURRENT CASTLE LINK VERSION: 3.255)... turned on the esc... the lights come on...
the fan starts up high and then settles when the yellow lights start to blink (but stays on a slower spin rate)... the Light react to the throttle
positions, forward, reverse and neutral... but no movement.

Alien

[brushlessboy16]

Originally Posted by ANGRY-ALIEN

Hmmmm... good to know you got the fix working.



No go for me man... I downloaded the new firmware (CURRENT CASTLE LINK VERSION: 3.255)... turned on the esc... the lights come on...
the fan starts up high and then settles when the yellow lights start to blink (but stays on a slower spin rate)... the Light react to the throttle
positions, forward, reverse and neutral... but no movement.

Alien

GO to the original firmware. then I went back to the brand new stuff, ( I got an error the first time), so old, new, than reinstall new.

and mine is back from the dead.

[ANGRY-ALIEN]

Originally Posted by brushlessboy16

GO to the original firmware. then I went back to the brand new stuff, ( I got an error the first time), so old, new, than reinstall new.

and mine is back from the dead.

Still the same result... Do I send it to Castle for them to have a look at it?


Alien