Insight into 2350 Flux equipment? - RC-Monster Forums

Pdelcast · 08.13.2010, 03:50 PM

Quote:

Originally Posted by simplechamp

I really like that the Q-base has all solder post connections. I wish the MMP was available in this configuration. It's nice to have the motor solder posts on the MMP 1-cell, but then you give up the fan and internal BEC, and the battery wires are still soldered to the board.

Is there any way to buy the Q-base as a stand-alone item? Contact HPI? Or look at the RC "chop shops" on Ebay?

I believe HPI will be selling the Q-base as a stand-alone product.

Thanx!

08.13.2010, 05:24 PM

So given a bone stock Flux HP and Flux 2350 with the exact same 4S lipo's installed in both and ran them side by side, what would we be looking at as far as performance comparison?

Pdelcast · 08.13.2010, 05:27 PM

Quote:

Originally Posted by Freezebyte

So given a bone stock Flux HP and Flux 2350 with the exact same 4S lipo's installed in both and ran them side by side, what would we be looking at as far as performance comparison?

Really a question for HPI -- I don't know... I've never driven a Flux with the 2350 motor in it. :)