build a gmaxx and i need help

[Rivermaxx]

So now you are going to have to buy 2 hard to (get & find) custom made bones instead of one.You need +10mm bone in addition to what?? IMHO I would use a standard ue 57.5mm titanium bone the front and figure out the back after mock up. If this helps I have these bones availiable. UE titanium 57.5 , 70mm and 100.5mm. I also have rcalloys stainless 57mm and 95mm. I have steel 70mm,94mm,110mm and 142mm.

[ANGRY-ALIEN]

Maxxrickard, since you are using the FLM chassis and monoblock combo... your chassis will be the same length as mine... the drive train should be the same as well since your using the spider CD...
I don't see why you can't use the Savage XL center shafts... It's not a tight fit, so I used a little fuel tubing in each drive cup to reduce movement of shafts....

Did you drill the holes in the center skid to install the CD mount yet? if not... do a dry mock up with some dowels cut just over 142mm and 63mm... put them together and see if the fit will work
for you... if so, you will have a cheap fix to the drive shaft problem...

See the pic below:



If you look closely, you will see the small piece of fuel tubing in the cup apply outward pressure on the drive shaft


Alien