delrin or simular material source

[tashpop]

awsome, i'm basically looking for 4x4 and up sheets of 3/8 or thicker material. i'm sure if you have thinner 1/4 stuff i can find uses for that too. i figured delrin would be my best bet like mentioned before becuase it can hold a thread. i'm just using it for fabricating various rc parts since i don't have real machining equipment and some parts i need i think delrin would work just fine with. i was also looking for some hex stock too to use for tvp spacers on my cen gst.

[JThiessen]

Your gonna spend some bucks on sheets that big. We order 4'x4' x 1/2" sheets of Nylon type 6 and delrin, usually around 200 or more a piece.

Just for clarification, do you mean 4 feet or 4 inches?

[J57ltr]

Originally Posted by tashpop

awsome, i'm basically looking for 4x4 and up sheets of 3/8 or thicker material. i'm sure if you have thinner 1/4 stuff i can find uses for that too. i figured delrin would be my best bet like mentioned before becuase it can hold a thread. i'm just using it for fabricating various rc parts since i don't have real machining equipment and some parts i need i think delrin would work just fine with. i was also looking for some hex stock too to use for tvp spacers on my cen gst.

Sorry been out of town.....again.

I don't have much in the 3/8" or less thickness in Delrin. Most of that is either 3/4" or 1". I also have 7/16", 1",2 1/2" round bar.

I have 1/4" and 3/8" in UHMW, and I do have some pieces that are about 4" X 4" (Also have 1" thick in this material)

Email or Pm me if you want any of those.

Jeff