Got my 30T RCM pinion - RC-Monster Forums

snellemin · 01.23.2011, 09:38 PM

Installed the 28T in the GTP that runs on 4s. I jumped from 23T to the 28T. I had no room for the 30T. Estimated speed is about 68MPH with the 47T spur. No bad for 4s. I'm hoping to push close to 80MPH with 4s and 1.5D 1515. Maybe more if someone can make me a smaller spool mount. Pletty was at 159F after a few runs, Acepow was just chilling and RX8 had 3 led on.

J57ltr · 01.23.2011, 10:14 PM

Damn that Plett is dead sexy. I think I would mount it to the wall or put a frame around it. So you like those Ace Lipo's huh? Do the RCM Pinion's have a different tooth profile. We need to go find a good place to run.

Jeff

snellemin · 01.23.2011, 10:39 PM

hehehehe. I have two dead pletty's in the garage and haven't found a spot to hang them yet. I'm liking the Acepow's alot. There are 2 more on the way. Last I heard they were at Hong Kong customs. I'm hoping they were build with thicker power wires.
The RCM pinions are a bit rusty, but nothing a bit of Royal Purple can't take care off. Monster Mike would have details about his pinions.
I only run my cars at nite at the moment. Family life keeping me busy.