Kyosho DRX brushless conversion

Made some progress today. This motor is way too big for this mount, I had to create some room for it to fit.


I was planning to have the mount screws to enter from the bottom, but the motor is so large the nuts don't fit :). This thing is going to be a monster...
So the nuts are hanging from the bottom, not very slick but it works.


Next I made a rear rest thing for the motor, it's from the DBX VE so I used it. It too had to be fitted for this large motor (+ room for a screw on the motor).


This is the result. I am still waiting for that HK ESC. This is going to be cool...

[nascarfan3199]

Are the mounting holes for the motor mount in the chassis slotted? If they are, as simple as that mount is I would cut my own out of a peice of alum. angle and then tap the hole in the mount so you can you a flat head screw so its flush with the chassis. They way it is now works but I think if you will be running on pavement before you know it the nuts will be ground down to nothing.