Steering servo

[Sneeck]

Servo horn and linkage. And some dry type lubricant(do not use wet type grease on the saver, sand will stick to it and cause allot of wear).

[Klausen]

Hi again

I just wanted to try with the blue metal servohorn directly. But the holes are way too small, for the stock screw.

Is there some screws that are made to fit the hole in the servo horn?

Best regards
Jesper

[HotnCold]

You might want to drill the servo arm ballstud hole opening a little bigger - Its aluminum - so the strength will still be there.