outrunner 4060 - RC-Monster Forums

coolhandcountry · 12.14.2011, 03:03 PM

Is this outrunner sealed up?
I remember most outrunners beening equiped with lots of holes and such.
Mud in motor sounds bad.
Just a thought.

steveo · 12.14.2011, 11:37 PM

i have an extra 1520 that was planning on using but its fun to try some new, as far as the tranny i have steel idler gears full metal would be greatbut not gonna happen i have had good luck with the tranny so far there should be a fuse in the driveline anyway

suicideneil · 12.15.2011, 10:45 AM

Quote:

Originally Posted by steveo

i have an extra 1520 that was planning on using but its fun to try some new, as far as the tranny i have steel idler gears full metal would be greatbut not gonna happen i have had good luck with the tranny so far there should be a fuse in the driveline anyway

Steel idlers is a start, but I hope the top gear has had the roll-pin replaced with something stronger, and I hope the slipper clutch has been upgraded too ( the slipper is the fuse normally

)..