Tekno Revo 3.3 conversion help

[magman]

1. On the batts....w/the hyperion it should tell you the % in the batt.
2. When you tried 6s were the batts wired correctly together as 2 3s packs in series or was it a single 6s pack?

On 6s that should almost be uncontrollable so something is definitely wrong. I would first check batts for fully charged, then check esc settings. Make sure voltage is correct, punch control etc...

[revo2200kv]

I tied the 2 3s in series. So the TCS on the charger is the charge percentage of the battery, correct? Well if that is the case my first pack was fully charged and the performance was very weak. Could I possibly have the motor connected wrong? The instructions didnt give a clear description.

ESC Settings
1. Voltage cutoff=3.4v/cell
2. Running mode= Forward with pause then reverse
3. Motor Timing=Normal
4. Initial acceleration=Very High(highest setting)
5. Throttle Percent Reverse=30%
6. Throttle Limit=90%
7. Percentage Brake=40%
8. Percent Brake Drag=0%
9. Motor Rotation=normal
10. Neutral Range=.4%