FLM Emaxx Install

[Emaxx Derek]

So I need 74mm front and 131 mm rear then.

I'm assuming using the bones that came with the flm chassis... Kershaw has been the only one to contact me back. Mike said he might have something from past project. What a bummer no one makes custom lengths. I might have thought again about venturing into this if I knew my truck was going to be down for a while because of this... Oh well I'm sure there is resolution.

Will any "dog bones work"? http:// http://www.ebay.com/itm/RedC...item53edbbf69a

[_paralyzed_]

That particular dog bone you linked to is 1/5 scale and won't work, but you're on the right track.


So the first measurements you gave were to the bottom of the cup? You said "end" so I thought you meant outside edge.

Are you running traxxas diffs front and rear? If they are 1/8 scale diffs you may also be able to use cvd's.