ESC Firmware Suggestions

[JoFreak]

"Significantly increased startup torque. Decreased delay of power from start"
So, does THIS mean the start up is as soft as it once was?

[Pdelcast]

Originally Posted by JoFreak

"Significantly increased startup torque. Decreased delay of power from start"
So, does THIS mean the start up is as soft as it once was?

No, it means the opposite.

It means the startup is faster and more torquey.

If you want a softer startup, you can use the link to decrease start power. This will slow down and soften the startup.

[outlaw]

After more testing / driving i really start loving the 1.45 on my MMP

question here
are there any changes made to the fan control ?
My MMP comes off the track with about 85F but the Fan run's

[Thomas Porfert]

There were some changes to the temperature control in the newer firmware versions. The fan will come on at a much lower temperature and the thermal protection will kick on at a bit lower temp. We actually found that on the MMP the thermal cut-off wasn't even working on some firmware versions.

Thomas Porfert
Tech Support
Castle Creations

[outlaw]

Thx Thomas !

good work so far on the 1.45
i like to have the fan on sooner !

*still dreaming about 1415 .5Y*

[bdebde]

Originally Posted by Thomas Porfert

There were some changes to the temperature control in the newer firmware versions. The fan will come on at a much lower temperature and the thermal protection will kick on at a bit lower temp. We actually found that on the MMP the thermal cut-off wasn't even working on some firmware versions.

Thomas Porfert
Tech Support
Castle Creations

So what firmware versions does the thermal cut off not work? I have many MMP's and rarely ever change firmware, and would like to know if I have one that should be upgraded.