 |
|
|
|
 |
 |
 |
|
 |
|
(#10)
|
|
RC-Monster Carbon Fiber
Offline
Posts: 89
Join Date: Oct 2005
Location: New England
|
05.02.2006, 04:33 PM
from what FMA's website states, you can set it to have a custom low voltage cutoff point that can be easily programmed by using a volt meter and flipping a tiny switch on the printed circuit board. It works with both brushed and brushless ESCs.
question is, what is a good low voltage cutoff point??? justin |
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
