bk 9920 problem... help needed before returning product...

SJCRSS, you seem to be right, it's really strange that the instructions say that we have to cut the red wire + unplug the black jumper!!! It's one or the other, but not the 2 at the same time... i'm agree with you.
I will submit your remark to BKelectronics and see... Your way is pretty logical, I think it's the way to go...


All thanks for your help all, I hope that it's my solution. If it's right, I will PM Mike to update the Warrior instructions, cause I'm not the only one to encounter these problems...

[sjcrss]

I've been in brushless way back when Modeltech was around, and back then you just pulled the red wire...and didn't even pull the black jumper. I've never heard of doing both, but I have heard of doing one or the other.....In my case ...because the MIcro's are programmable via a pc.....pulling the black jumper wasn't a option for me...so I made a short servo lead with the red wire missing...and then I plugged in my controller lead into it....that way all i had to do was unplug it and I could program my controller.....but still have the BEC disabled when I plugged it into my lead with the red wire missing. I hope this helps.