Interference - RC-Monster Forums

		RC-Monster Forums > Support Forums > Brushless
Interference

Reply

Rate Thread

	(#1)
RC-Monster Mike Site Owner Offline Posts: 4,915 Join Date: Nov 2004 Location: PA	01.23.2005, 10:57 PM You shouldn't get any interference. I would re-solder the motor wires so they are shorter and run directly to the controller (maybe on opposite side of the motor solder board). The Novak is a cluster of wires!

Reply

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Forum Rules

Forum Jump

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com