Looking for a buggy project

Originally Posted by BrianG

I was going to try to do it myself, but there's no way I was going to be able to make an integrated design that would fit right and be sturdy.

Exactly why I am letting Mike cnc me a motor/diff mount. I have tried to make make one on my e-maxx and could not get it sturdy enough...

Bye:018:

[BrianG]

Originally Posted by cemetery gates

Exactly why I am letting Mike cnc me a motor/diff mount. I have tried to make make one on my e-maxx and could not get it sturdy enough...

Bye:018:

So you decided to finish the emaxx after all, eh? Oh well, it's only money right? You can't take it with you. :027:

Originally Posted by BrianG

So you decided to finish the emaxx after all, eh? Oh well, it's only money right? You can't take it with you. :027:

No, the mount is for LSP.

I took some measurements and braced the bulks together front to rear on the e-maxx on the chassis. The chassis turned out to not be straight, only off by like 1cm front to back, but enough to throw everything else off. So, my LSP will soon be brushless...

Bye:018:

[BrianG]

Originally Posted by cemetery gates

No, the mount is for LSP.

I took some measurements and braced the bulks together front to rear on the e-maxx on the chassis. The chassis turned out to not be straight, only off by like 1cm front to back, but enough to throw everything else off. So, my LSP will soon be brushless...

Bye:018:

Ah, I see. If I had read both of your last posts, I would have realized that. :007: