mamba max brushed

[sven]

Originally Posted by jollyjumper

high-end handwounds go from 85€ to 110€ here.
i was wondering, will mamba handle 2 motors (brushed):032:

You could probably run quite a few brushed motors off of the MM. :027:
I use the Mamba Max in my clod crawler, running 2 55t lathe motors in parallel. It is great for that application due to the drag brakes.

[jollyjumper]

one would need a data logger to be sure.
so one can measure amp draw of the motors.
but i'm sure mambamax' wouldnt handle alot more then 2 motors.

[sven]

Granted this is with 55turn motors, but this is a post from rccrawler:

http://www.rccrawler.com/forum/showp...1&postcount=49

Originally Posted by johnrobholmes

If we assume the stall amperage is 20 amps ( just a guess) on 9 cells, we find that 20 amps x 1.2 volts/cell x 9 cells = 216 watts. The mamba maxx is capable of 1000 watts continous, so you could run 4 55t lathe motors stalled in parallel forever and have no problems. Again, this is assuming 20 amps stall per motor on 9 cells. Im gonna look for a lathe motor and a 9 cell pack...



The 55t lathe motors on the other hand, would not be able to handle 9 cells when stalled forever

[jollyjumper]

ha yes.
that interesting.
but mod motors pull more then 20 amps.