Radio for brushless vehicles

I am having trouble programming the MM using the 3PK. The receiver that came with the radio is a HRS (high response system) and transmits data too fast for me to keep up with the beeps. In the 3PK manual, it says to use a DSC cord and a two way cord to program any non-futaba ESCs. I have tried this, but i am still having problems. Has anyone programmed a MM ESC with a 3PK with a HRS receiver?

I know I can program it on a computer, but I only have a Mac

You could try to switch modulation. Try PPM. Page 16 in the manual. I have to admit that I haven't tried this myself with the 3PK, only the EX-10. It should work though. I don't know if you can switch back to HRS after programming the esc and keep the settings you stored in PPM mode. Do you have a digital servo?

Servo is digital, the manual says that you must use a DSC cord and a two way cord, but the guy at the local hobby shop said i could plug the dsc cord into the hrs receiver and plug the MM into the receiver, but this created the same problem. Can i use PPM mode sith a HRS receiver, the manual says not to.

[squeeforever]

I think you still need to do the basic programming with the radio. Not 100% sure, but I think that you have to do the basic forward-nuetral-reverse with the TX. Everything else can be done with the PC.

That is not a problem, as its just hold the throttle then brake, it gets too tricky later on in the programming when you have to determine between 7 or 8 beeps that all sound like one.
Does the HRS receiver perform much better than a normal fm receiver?