New MGM problem?

[BrianG]

Well then, if you only had your UBEC hooked up, I would suggest checking the output of the UBEC. If it is faulty, it can send full battery voltage as well...

[pb4ugo]

Originally Posted by BrianG

Well then, if you only had your UBEC hooked up, I would suggest checking the output of the UBEC. If it is faulty, it can send full battery voltage as well...

Forgot to mention that voltage at the receiver was 5.57-5.58 the whole time (I have a Sensor). The transceiver still powers up and connects with my transmitter (for those unfamiliar with the Sensor, there is aubible and visible confirmation of events such as these), there just isn't any transfer of signal to the servos. Well there was, until I plugged in my MGM.

[zeropointbug]

Sounds like the MGM controllers are more of a burden than an investment.:002:

[pb4ugo]

Originally Posted by zeropointbug

Sounds like the MGM controllers are more of a burden than an investment.:002:

Hasn't been fun for me. In 9 months of owning this, I've had 10 minutes of run time. It also looks like it has cost me $200 worth of receivers on top of the $325 I bought it for.

[zeropointbug]

Seriously man, I feel sorry for you. I've had stuff like this happen to me with electronics i've bought, not fun. :019: