More 1/8 scale truggy fun vid

And its alot heavier than stock nitro version + heavy chinese wheels so the damage isent that bad, just need the alu hubs.

[gtxracer]

The 1900 is a buggy motor and I wouldn't recommend running it in any truggy. The MMPro might be able to handle it for a while, I ran one in my RC8T for a little while and it did fine.

[nastety92]

Originally Posted by gtxracer

The 1900 is a buggy motor and I wouldn't recommend running it in any truggy. The MMPro might be able to handle it for a while, I ran one in my RC8T for a little while and it did fine.

So I guess I should go with the 1700kv motor insted.

I can say that I do not know much about these motors but I really want to be able to run the motor sensored. Ever since I hooked up my SC10 with a sensored motor now I want one for every truck.

Thanks for the help,
Nick

[gtxracer]

All of the Tekin motors are sensored and work with the MMPro so you're good to go there. The lower kv motors are more efficient and give better runtimes. I think they run cooler but maybe that's just my opinion. The 1700 is a good choice you can run it anywhere from 4s-6s without worry.

[nastety92]

Originally Posted by gtxracer

All of the Tekin motors are sensored and work with the MMPro so you're good to go there. The lower kv motors are more efficient and give better runtimes. I think they run cooler but maybe that's just my opinion. The 1700 is a good choice you can run it anywhere from 4s-6s without worry.

Thanks for all of the info. This is exactly what I'm looking for.

Have you ever tried running this motor on 3s to see what happens?

So at this point in your build. If you were to do anything differently, what would it be and why?

Thanks again,
Nick

[gtxracer]

Thanks Freddy! Post some pics and a vid if you can when you get your setup running.

[gtxracer]

Jumping the dunes:
http://www.youtube.com/watch?v=L6aFImjTDjs

Resulted in:

[gtxracer]

You broke the rear hubs? I broke the front plus the spindle and bent the hinge pin. I'm going to buy the aluminum hubs if I break one again.

[gtxracer]

That was a pretty hard hit though. I'll be honest, I've broken a few Mugen arms doing the same thing on the front end.