My motor is toast already... :(

[brushlessboy16]

news flash....


just got the warhead together...
pretty sure i got screwed over on the 8xl ran good for the first few seconds.... then went south.


I set the truck on my floor, and fired it up-calibrated my MM, everything was good.
forgot reverse stength.... did a frontflip on my floor, WOOHOO


then shut it down, took it outside on our concrete patio.. started up just fine... went off throttle just enough to move then it locked... then noticed that the rotor had almost a full centimeter of play...


Pretty sure i got effed over in this dea.

and now im out of money so this project is postponed untill further notice.



i dont know if it was my fault or not, the motor wasnt even above ambient temp when it happpened...





now my motor doesnt spin at all and the rotor sticks out both ends equally...