how to reverse a servo in this application?

[mamba max1]

Hey all,


Long story short, I made a swiveling camera mount attached via a Y harness to my steering servo. Made it this way so that the camera faces where the truck turns. Only problem, is the cam mount servo runs reverse to my steering direction. Because of how its hooked up, reversing its direction via my remote wont work. I know I could buy a servo reverser, but I'd rather save my money. So, is there a way I can reverse something in the servo by soldering? I'm fairly decent at soldering so I'm not afraid of attacking the circuit board (plus the servo is a cheepie)


Thanks :)