Hyper 7 direct drive

Well I have lost intrest in this project. Anyone want to continue with it??
I purchased a motor and batteries some time ago and am tired of it. I need inspiration or get rid of it.

Oufffffffffff!!!! must put alot of stress on the motor

[Serum]

He said he needed inspiration..

It's not that hard to finish it;

get 2 UE 8mm cups, got two cups for the piniongear of the diffs, measure distance, shoot mike an email on what length of dogbones you need, and you are good to go..

I have the cups. I did not know Mike makes bones that is good news.


David;
Stress on the motor?? Are you talking about the mount?

No! forget it. After think twice, it's same thing that any 1/8 scale conversion with center diff, where the motor pinion directly drive the spur

Excuse me, i've don't realy take time to weak-up my mind before to post

[ilpufxit]

I too have a Hyper7 with an unfinished conversion. I started to set it up with an Align 600xl in a regular pinion to center diff configuration..The mount is done but I need a 6s battery and a controller that can take it. I just got sidetracked with too many other projects. If I ever do get it done, it will be a real screamer I'm sure.

[brushlessboy16]

what motor is that?

HXT 50-55A 400kv

[brushlessboy16]

and the outdrives on the motor?

There is no out drives. It is the shaft in the motor which is 8mm and fits the drive cups of an 1/8 scale buggy.

[brushlessboy16]

oh i was wrong, i got confused with outdrives and drive cups, thanks for the help

Well;
I am going to get rid of it. I have no intrest in finishing it. Anyone want it before it goes to ebay. I am going to throw in a 5s 4000 mah battery.

Dan