Dream Monster!!!

[lipomax]

I'm in the process of building it right now...

Emaxx
G Maxx carbon fiber extended chassis
G maxx suspension
7.5 6 spyder diff setup
Hybrid bulks
T Bonz
6s 3200 Kokam, 8s 3500 polyquest, or 10s 4400 polyquest (depending on how fast I wanna go)
RPM steering blocks with large bearings
Lunsford 4mm ti-rods
Robinson racing slipper clutch
Fastlane shock towers
ProLine shock absorbers
Spektrum radio
Some airtronics 200 oz .10 60 servo
HD servo saver
Schulze 24.89 with 6.0 volt UBEC (good only to 8s lipo)
Genesis Truck (only good to 4s lipo)
Motor? Only the Basic XL 1200, 1600, 2400 so far...

[Sneeck]

Scratch those rpm bearing knuckle's. They will wear after time causing the bearing's to wobble.

[coolhandcountry]

I would buy the integy knuckles over the rpm. I have had both and the integy is much better.

[lipomax]

modification to my maxx:

UE CVDs - no T Bonz
Thanks for the info on the RPM knuckles. When they get sloppy, I'll change them.

[Dafni]

I have never been afraid to drive my trucks. If something breakes, it gets fixed, and scratches just add flavour! :)

Dream truck is pretty much what I'm building now, I call it the G3R :) because it has 3 diffs.
But in my dreams it has 1/8 diffs front and rear too, a telemetry radio, and instead of Lipos it would have a fuel cell!! Watch out boys!
The Lehner could stay, though.

:D Cheers

DAF