Speed Calculator

[coolhandcountry]

Well it has been probably that long since looked over here much.
But I like what you have done with the site.
I trying to get back into a few projects just not as serious as used to be.

[brian015]

The LED calculator (nice feature) didn't like the 300mA current of these LED's I was thinking of buying to make some homemade flashlights for my kids:

http://www.ebay.com/itm/5-PCS-10mm-4...item5adb4fdf33

[BrianG]

Yeah, the calc has a built-in limit of 99mA. This is to prevent people from thinking "well, I'll just dump more current to make my LED brighter" which would quickly destroy their LEDs (or reduce their life drastically) and then they'd blame me . TBH, even 99mA is quite high for the typical LED used for R/C lights, which usually have values in the 25mA range.

But, at the bottom of the page ("Other Useful LED Information"), the formulas that the calc uses are listed. Just pick the right one for your application.

[Bmr4life]

Additions.

Ofna DM1 & DM1E
front and rear diffs - 3.3076923076923075
Center Spur - 49t


Traxxas XO-1
front and rear diffs - 2.846
Center Spur - 46t
Stock Belted Slicks - 4.29"

[speedy]

Will there be a mobileverson of this site out soon ?
The speedcalculator don't work corektly on my ipad

[BrianG]

iOS/OSX purposely not supported. I don't like crApple.

Seriously, it should work. Haven't touched the site in a loooong time. Not nearly as much traffic as it used to have. Seems like R/C has become less popular in general, and most companies have systems pre-built so not nearly as much call for conversions and the calculations they entail.

[SnoopMaxx]

Originally Posted by BrianG

iOS/OSX purposely not supported. I don't like crApple.

Seriously, it should work. Haven't touched the site in a loooong time. Not nearly as much traffic as it used to have. Seems like R/C has become less popular in general, and most companies have systems pre-built so not nearly as much call for conversions and the calculations they entail.

I still use it at a regular basis

[Kcaz25]

Why is the tekin 2000 4038 listed as 2100kv?

[Emaxx_Quebec]

Me too!!

[RC-Monster Mike]

And me too. :)

[Kcaz25]

Me too, what about the Tekin? Is it actually a 2100kv?

[RC-Monster Mike]

Tekin has a 2000Kv and a 2250Kv truggy sized motor - not sure why it shows as 2100?

[Kcaz25]

I was doing calculations for my Losi 2.0 buggy, which BTW is not supported in the f/r diff department. But I know what the ratio is.13/43. I just picked up a Tekin t8 4038 truggy 2000kv and was trying to pick out a pinion, when I noticed on the calculator that the tekin 2000kv calculates not at 2000 but at 2100. I was wondering if after some testing if BrianG or anyone else really discovered that the wind is really 2100. I used a 15t pinion and ran the buggy last night and its perfect.

Thanks for the calculator, I've been using it for years! It would be cool if the lists were updated a little bit.

[RC-Monster Mike]

It is more likely a typo than an adjustment to the posted Kv. I normally manually enter motor Kv when I use the tool, along with battery voltage. :)

[ruudxd]

I use it also, very helpfull for gearing etc!