started to on one motor but any deeper might go through the can so i held off.

its a rcm part. but the bearings i added myself. mike could probably machine it for bearings if you asked him to

Ryu- tryed to pm you about a neu motor, your pm box was full

it wasnt full yet but i just deleted a bunch so try again. or you can email me through RCM too. my profile is set to accept emails.

pm prompt.........

i just checked everything and all private message recieval is enabled. i will pm you my cell # and just call me.

i think i fixed it. when i setup my buddy list it automatically made it so i could only get messages from them. now i changed it back to recieve messages from anyone.