got a link?

sure give me a sec

HERE is for the STAMPEDE

First off, GorillaMaxx360 does that require two posts? :005:

Here's the 2.5R/3.3 RPM Arms The exact ones that I got for $41.96 with shipping :031: (Actually not bad but I wanted to use that emotion

So will see how they are when they get here.


Josh :028:

The RPM 3.3 arms have been out at least since August. I converted my emaxx to the 3.3 arms, steering knuckles, and sliders back then and I think they were out for a good month or so before that.
http://www.rc-monster.com/forum/showthread.php?t=3588
Heres the thread. It actually calls the part number list that you need to do the 3.3 slider/arm/steering knuckle conversion somewhere in it. With the RMP arms and the 3.3 sliders I have been running trouble free ever since.

Another cool benefit of the 3.3 arm/steering knuckle/slider conversion is that it gets you another 1" of width vs the 2.5 knuckles.

Do I need 3.3 Knuckles and the sliders to be able to work the 3.3 RPM Arms?

Josh :028:

The 3.3 arms will work w/ either 3.3 stuff or 2.5 stuff. Only difference between the 3.3 and 2.5 arms is a little cut out for clearance on the wider diameter 3.3 sliders.

To do the 3.3 sliders and 3.3 knuckles need to be done together. You can't one without the other.

Phew that's a relief. All I bought was the RPM 3.3 Arms. So no other reason to crack open the wallet. Thanks for the information ;)

Josh :028:

did you find what your looking for

I haven't searched. I was just curious for the most part because I have not seen the 3.3 RPM arms yet.

ok cool

All the new RPM Maxx arms are 3.3 ready..

So they are jsut like 2.5's but they are "precut" to fit the 3.3 knuckles and sliders right?

Yes, Correct

thanks!