12020 Question
 

There is a lot of wires coming off of this thing, 6 blue ones and two black and two red. could someone tell me what to do with all these and where to solder them?

Just treat the pairs as if they were one wire!
You'll get 3 motor wire pairs, and a black pair and a red pair.

I take it you have some experience with BL, so I wont type the whole story. But feel free to ask if you get a problem.

actually i have NO experience with BL just my mamba. what are th eblue wires for?

the blue wires go to the motor. there is 6 and there in pairs. just solder the female connectors to the motor wires and the male connectors to the blue wires.

http://www.rc-monster.com/forum/show...5&pagenumber=2

theres a picture of mine all wired up.

can you send me a full size pic to vwghiadude@Hotmail.com

Just wire each pair of bleu wires to a motor lead. Order is not relevant.

And wire your cells between the Black and Red pair. If you use 2 packs, wire in a way so that all cells are in series.

ok, how come it is two wires to each motor lead?

i know how to wire it all now. next step is BATTERIES. Yay

lol! u jumped into a 12020 without a 9920 first! lol, have fun bro!

I will, i am trying to find a spot to momunt the ESC right now though, it is kind of hard

i might need to mount it on the outside of the TVP for now, there is NO room at all,

here this picture might help with the wiring.

toby, I would keep the ESC on the inside of the TVPs. Or when you want to put it on the outside, make a cover.

Did you get a warrior or micro, btw?

warrior, i cannot find any room for it on the inside, so i dunno where to mount it

Does the 9920 have 6 wires like that? Where they need to be paired for the motor? If so I need more connectors! Might just direct solder them...

i am going to direct solder them to the motr, can i cut the blue wires down a bit?