Problem programming 9920
 

Hello,

I finally got my savage build up and got the warrior 9920 with the 7XL motor.

I'm trying to program it but I can't do it so far. I tried the way of Mike, the way of the instruction guide from BK, but that doesn't work. I only hear one beeb and when I hit full throttle, I don't hear anything anymore.

But it does work when i

1. connect the motor wires
2. plug in the wire from the warrior in the receiver.
3. plug in the drive cells
4. Put on the transmitter
Then I hear one BEEP, then I hit full throttle, and then I hear two BEEPS. I thought that the controller is then programmed succesfully. But when I put on the red jumper en connect all the wires. The motor is driving full throttle backwards. And then I can't get the red jumper off the esc because I think this isn't right.

Can someone helpe me pleaseeeee

I WANT TO DRIVE THIS BEAST!!!

what does it do? does it drive full throttle backwards when you connect the batts?

On your transmitter, try reversing the throttle channel (channel 2). If the Warrior 9920 can't recognize full throttle, and sees reverse instead, it can get all messed up.

It is solved, i helped him thru MSN...

way to go serum. :D What was the problem?

Several..

plugged in channel 1 for a while (as a test) and forget to plug it into 2nd channel, we enlarged the EPA, and he needed to put it in reverse as well. weird thing, that he could programm it the first time though..

good job seruM!