Front bearing Unglued itself on 2200kV motor
 

Hello,
I encounter a small issue with my Castle motor.
Since some times, I stated some moves in my front bearing and rotor, I could move it a little.
First I tought it was my front bearing which was used prematuraly, but in fact I realize that the bearing was unglued off the bell as I can push it a little back when I push the rotor in the motor (0,5mm).
I opened the motor, dust it off and glued it myself. By the way the bearing was still in good shape, happy to state it :yes:!
Once the motor closed, no more moves in the rotor and bearing :yipi:
So if you have this king of moves issues, check that the bearing is always glued in the bell by pushing the rotor in the motor.