Temporary RX wire fix? Yes/no?
 

In a rare event the RX wire(s) pulled apart. :gasp: Can I put the wires(3) back together without soldering for a couple of weeks until I am able to solder them? Please say yes! :yes:

Thanks
Zack

of course

How do you suggest? Tape and loads of care?

Good news!

Strip back .25" from both sides twist together and tape each - Then tape everything.

Thanks this did indeed do the trick! :wink:

Yep its still working, in fact I forgot about until I moved my RX. Its been moved right beside my MMM and now that big ugly taped black wire is in the way and too long. I was thinking maybe I could undo the tape and add the RX plug at the end of the old damaged wire piece.

So my question is this... How do I remove the wire from the plug and how do I put it back again once I have removed it?

Thanks,
Zack

The ends of the wires ( inside the plug ) have tiny little metal pins crimped on, it would be pretty much impossible to uncrimp the wires and put the connectors back on again. You could shorten the wires a bit more and then retape, though your best option is to shorten and solder the wires back together, using some very narrow heatshrink tubing to do a cleaner job..

Put a Servo connector on where the wire break is, they do (as stated) crimp on and then just move the receiver.

Ah I see, bummer thanks Neil

Ben,
You mean buy a new open RX plug? I didn't think of that, I'm going to look and see if they sell them.