Sluggish acceleration
 

Hi !

My 1900kv motor acts like an nitro engine runing rich what could cause this ?
It's a new motor and i have 5000mah 40c + lipos.
Mybesc setup are: timing:low acc :high and no punchcontrol.

I think it was the timeing that were set to low :) i increased it to normal and the motor got a'lot more snapier

Hm the motor is still reving up very slowly ? What can cause this ? Could it be that i,m used to 2 pole motors ? Because they are snappier than 4 pole motors right ?

Reset the ESC to default..

Why? The motor preformance was worse with the default settings !

That's weird. What motor and ESC do you have?

The motor is runing cool after 10-15mins of bashing the motor temp was 35celsius and the esc 15c


Does 4pole motors like high or low timeing in general ?

I think the 4 pole motor generally likes low timing. btw is that really a 4pole motor?

Thomas G

Wow I must say that is the most blatent cc rip off of a mmm I have seen so far. Can't comment on getting your motor to snap harder, Since it's not a cc esc I donk know what kind of programing it has, all mine hit max rpm in about a second in my rigs. D wind four pole likes low timing and y wind four pole likes higher timing. Make sure your connections are all good.

Bloody hell is it ever!!!:surprised: The casing looks identical and I bet they even had a decent go of copying the internals. At least TORO/Trackstar tried to make it sort of look like the RX8. That is about as blatent as it gets.

wow that is pathetic! They even gave it a CC type name....the Anaconda!:lol:

Anacondas are for girly men... Mambas are for real men!