Spur gear for G2R ?
 

Is this (http://www2.towerhobbies.com/cgi-bin...p?&I=LXBJC6&P=) working for e-maxx tranny?
Spur gear on my G2R was melted about 1 min I ran my truck.
I'd like to change to stronger spur gear.

NEVER go with steel unless you can't help it. Get the plastic kit for a E-maxx or better yet, a Strobe setup. The steel requires a hardened pinion which is fairly expensive.

Ok.. I may stick with plastic spur...
Then... What kind of stobe setup would you recommend?

The Strobe slipper, a 51T Nylon spur gear, and a mod1 pinion should be all you need.

However, actually obtaining a strobe might be a challenge as they seem to be out of stock everywhere...

Thats cause they quite making them :mad:1 :012: :frown: :031: .

I guess I was smart then for ordering two! I still have one that has never been used, and it's all mine! haha! >:)

Somebody could make a few smackers bringing them back into productions...

You know, I mentioned that a while back in another thread and the guy at strobe jumped all over my case about "stealing ideas" and whatnot. Even though that wasn't my intent (to steal his design), the fact remains that the market wants something like that and if he can't deliver, someone else will. Nothing against Strobe - I love mine, but facts are facts.

I couldn't find out the stobe set.
Do you guys have any idea where I can buy one? Any link...?

If everybodys out of stock, then try Ebay.

I've been watching Ebay for 'em for a while also....no luck.
Anybody ever try the Robinson Racing Slipper set up http://www2.towerhobbies.com/cgi-bin...?&I=LXBJB5&P=0?

How about this one? (http://www2.towerhobbies.com/cgi-bin...?&I=LXBJB6&P=7)
Is this working for e-maxx tranny?

That one will work. Just make sure not to get the steel spur version.

get the plastic 72 tooth gear and it will be good, need a new pinion as well