![]() |
What motor can replace feigao 540c 7xl ?
I was thinking of buying the 7xl, but then I canīt use all the 1/8 pinion gears that I have. Is there any motor that can replace the 7xl with a 1/8 shaft ??
Or comes close to ?? Regards |
You would be far better off simply purchasing some 5mm shaft pinions - a 7XL with a 1/8" shaft will probably end up snapping it, espically if you plan to use it in a fairly heavy car.
|
I just can´t find 5 mm bore pinion anywhere. They are out of stock at RC-Monster for E-maxx (unless the mod1 5 mm can be used)
|
Mod-1 pinions are better than 32 pitch, however you would need a "strobe" slipper to use mod-1 spurs (1/8 buggy spurs).
I'm not sure where else you will find 32 pitch 5mm pinions, the ones I have were purchased from RC-Monster I'm fairly sure. |
I think I have tryed everywhere - guess I just have to wait.
By the way will the Quark 80B handle the 7xl ? can it be compaired to the warrior 9920 (out of stock also :-) ) |
You'll need a Quark 125b. You may also have to add a heatsink to it to keep it cool as well.
|
What other motors can be recomended that gives the same or more power/torque as the 7xl. with the Quark 125B
(for an E-revo with 2x7 cells /2s2p 8000 mah lipo) |
I have seen an XL on ebay with a a 1/8th shaft. I thought it was a 7XL..
|
Quote:
|
I was just about to put one of my Quark 125's on ebay it was all setup (5mm plugs,deans plug heat sink and a bec) All you would have to do is plug it in and strap it down. If your interested send me an email. You would probably be better off with an 8xl if your going to use lipo or good nihm's. It will still have plenty of power run cooler and give you longer run times. I also have a few 5mm 32 pitch gears if Mike cant hook you up with one.
|
smertzog: I´m interested. Give me your emailadress and lets see what we can find out.
Mine is - wittenborn@email.dk |
| All times are GMT -4. The time now is 08:22 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.