RC-Monster Forums - View Single Post - Pinion on a 5mm shaft.. is there a trick?

Trick440 · **Pinion on a 5mm shaft.. is there a trick? -** 05.03.2007, 02:20 PM

Ok I tried putting a pinion gear on my Nue motor 5mm shaft...

I think the pinion set screw threads where messed up already... I was just screwing it in not evenb tightening it and the treads came out.

What should I do when I get a new pinion.... should I grind a flat spot on the 5mm shaft so the set scre can screw in more?

This sucks cause I wanna try this thing!!!!!!!!!

	(#1)
Trick440 RC-Monster Carbon Fiber Offline Posts: 113 Join Date: Nov 2005	Pinion on a 5mm shaft.. is there a trick? - 05.03.2007, 02:20 PM Ok I tried putting a pinion gear on my Nue motor 5mm shaft... I think the pinion set screw threads where messed up already... I was just screwing it in not evenb tightening it and the treads came out. What should I do when I get a new pinion.... should I grind a flat spot on the 5mm shaft so the set scre can screw in more? This sucks cause I wanna try this thing!!!!!!!!!